Проверка кузова (стенд "Caroliner")
Проверка кузова : Стенд для проверки размеров "CAROLINER"
1. Рекомендуемые приспособления и инструмент
ВНИМАНИЕ : The purpose of the bolts referenced on the table of the illustration "checking a bare bodyshell", whose identification marks are positioned on the latter, is to ensure the correct centring of the adaptors for the recommended tool.
Обозначения :
- [ 1] M12 screw
- [2] M14 screw
- (1) Top of the body jig clamps (передние)
- (2) Top of the body jig clamps (задняя)
- (3) Centre line of clamps (передние)
- (4) Centre line of clamps (задняя)
2. Проверка разобранного кузова
3. Checking a vehicle (with the mechanical components in situ)
4. Checking the steering system
4.1. Checking dimensions
Theoretical dimension : L = 135,2 мм.
Theoretical dimension : L1 = 146 мм.
ОБЯЗАТЕЛЬНО : To ensure a correct checking, the 2 conditions below must be observed.
Condition 1.
Измерить размер L (слева и справа).
Измерить размер L1 (слева и справа).
The difference between the L.H. and RH readings must be inferior to 5 mm.
Condition 2.
Обозначения :
- A : Измеренные размеры (с левой стороны)
- B : Измеренные размеры (справа)
Измерить размер L (слева и справа).
Измерить размер L1 (слева и справа).
Transfer measured dimensions L, onto diagram L.
Transfer measured dimensions L1, onto diagram L1.
On each diagram, connect the 2 dots together by a straight line.
ОБЯЗАТЕЛЬНО : The 2 straight lines must not extend beyond the tolerance zone (shaded zone).
4.2. Пример
Checking dimension L1 | |||||
---|---|---|---|---|---|
Прямая линия | Measured dimension - Левая сторона | Measured dimension - Правая сторона | Condition 1 | Condition 2 - (см. схему) | Check result |
(1) | 148,5 мм | 144,5 мм | 148,5 - 144,5 = 4 < 5 мм. Condition fulfilled | Included in the tolerance zone. Condition fulfilled | Bodyshell correct |
(2) | 148,5 мм | 142,5 мм | 148,5 - 142,5 = 6 > 5 мм. Condition not fulfilled | Included in the tolerance zone. Condition fulfilled | Bodyshell not correct |
(3) | 143,5 мм | 142,5 мм | 143,5 - 142,5 = 1 < 5 мм. Condition fulfilled | Not included in the tolerance zone. Condition not fulfilled | Bodyshell not correct |